Juno Aqualac White Multi-Surface Trim Paint Reviews

High-Performance Water-Based Enamel for Professional Results Aqualac is a water-based acrylic enamel range developed for demanding interior and exterior applications. Formulated with fast-drying acrylic resins, each finish delivers strong weather resistance alongside a smooth, uniform surface with reliable hardness and levelling. All finishes are suitable for interior use, while only Gloss and Satin variants are designed for exterior exposure. Suitable Surfaces and Application Areas Designed for use on properly prepared substrates, including interior wood, plaster, drywall, exterior wood trims and doors, masonry, iron, steel, and galvanised or aluminium surfaces. Aqualac is particularly well suited to doors, trims, and cabinets, where consistent coverage and a refined finish are essential. Certified Safety and Environmental Performance Fire Retardant on non-combustible substrates: Certified B-s1, d0 according to EN 13501-1:2007+A1:2009 A+ Indoor Air Quality rating under ISO 16009-9 standards AgBB certified for low emissions to ISO 16000-6:2006 These approvals confirm suitability for residential, commercial, and healthcare settings, where fire performance and indoor air quality are critical considerations. Surface Preparation Guidelines All surfaces must be clean, dry, stable, and free from grease, dust, or loose material. Interior wood should be primed prior to coating. Iron and steel require the use of Metalex anti-rust primer. Aluminium and galvanised surfaces must be thoroughly degreased and prepared using Waterprim or a suitable multi-support primer. Previously coated surfaces should be lightly abraded to remove surface sheen and promote adhesion. Do not apply to cracked or split timber. Avoid application below 5°C, in direct sunlight, or when rain or strong winds are expected. Application and Finish Recommendations Apply by brush or enamel roller, spreading the coating evenly to achieve a consistent film. Two coats are recommended for exterior exposure. The enamel becomes touch dry after approximately one hour and can be recoated after 24 hours. Do not exceed eight days between coats. Clean tools and spills immediately with warm, soapy water. Restrictions and Environmental Considerations Do not apply to excessively hot, damp surfaces or in conditions of high humidity above 80%. Avoid use on wet, unprimed, or highly porous substrates. Never apply to cracked timber or where moisture content exceeds 15%. Do not dispose of residues into drains; waste must be handled via authorised disposal routes. The Matt finish is strictly for interior use only. Always Consult the Product Data Sheet For full technical guidance, refer to the latest product data sheet before use. This includes detailed preparation advice, application parameters, environmental guidance, and safety information specific to storage, handling, and disposal. If you’d like this tightened further for ecommerce, adapted for a trade audience, or split into PDP tabs, just let me know.